PowerMaster SGI
Commercial use, 115 Volts, ½ HP, gates of 2000 lb, 45 cycles per hour, 80 feet gate width, 11 inches per second. U/L 325 listed for use in Class I through IV applications
| Power |
115 Volts, 1 Phase |
| Frequency |
50-60 Hz |
| Available Horse Power |
1/2 HP |
| Maximun Gate Weight |
2000 lbs |
| Maximun Cycles per Hour |
45 |
| Maximun Gate Width |
80 feet |
| Gate Speed |
11 inches per second |
| Class 2 Low Voltage Control Circuit |
|
| U/L 325 Listed for use in Class I through IV |
|
| Weight |
275 lbs |
- Solid state P.C. board with Custom
- Programmed Micro Processor for state of the art control.
- External control, input terminal connections for:
- Radio Receivers
- Push Button Control Station
- Key Switches
- Loop Detectors
- Card Key Readers
- Telephone Entry Systems, etc.
- Timer to close with 0-60 sec. Adjustment standard.
- Longer timer available upon request.
- Maximum run timer for equipment protection (self adjusting)
- Master/Slave option with dedicated terminal connection provided.
- Easy Left/Right changeover.
- Time delay on reverse to ensure smooth gate motion and less stress on equipment.
- Spike suppressing circuitry for surge and lightning protection.
- Electrical dynamic brake for precise gate positioning.
- Magnetic gate lock control circuitry with 115 Volts output terminals
- Integral current sensing, anti-entrapment circuitry with independent opening and closing sensitivity adjustments.
- External anti-entrapment circuitry with separate terminal connections for easy installation of contact and non-contact sensors.
- ½ HP, 115 Volts AC, 5.5 Amp., 1 phase, instant reversing, switchless, PSC motor, with thermal overload protection for smooth, quiet operation.
- Internal ON/OFF power switch.
- Two grounded 115 Volts AC, 15 Amp. Convenience receptacles.
- NEMA 1 one-button control station included.
- Heavy duty #10 Ga. Galvanized steel frame providing a strong and durable unit.
- Hard shell, baked-on weather resistant powder coating, with an attractive textured finish, for years of aesthetic protection from the elements.
- 40:1 oil bath type gear reducer for long service and smooth, quiet operation.
- Heavy duty #50 drive chain with a spring loaded tensioning system for smooth starts, stops and reversals.
- Heavy duty, pillow block type ball bearing supporting output drive shaft, and enabling extended endurance under heavy loads with low maintenance.
- Padlockable drive disconnect, with brass slide for manual operation In case of power failure.
- Positive, chain driven, rotary limit switches for precision gate positioning. Settings are never affected by manual operation.
- Post or pad mountable for easy installation.
